Part Number Hot Search : 
Z0803606 TM12864G 84BJC AS170 84BJC TC114Y 74HCT405 MRF24J40
Product Description
Full Text Search
 

To Download ZL60007TBD Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
  obsolescence notice this product is obsolete. this information is available for your convenience only. for more information on zarlink?s obsolete products and replacement product lists, please visit http://products.zarlink.com/obsolete_products/
1 features ? data rate up to 622mbps ? 1310, 1550 nm pin ? tia with agc ? to-46 assembly ? 3.3v power supply applications ? sonet oc-12 ? sdh stm-4 ? atm 622mbps figure 1 - pin diagram data out v cc data out case gnd bottom view description this optical receiver is a 3.3v device which contains an ingaas pin photodiode and a transimpedance amplifier with automatic ga in control and dc restore circuit assembled in a to-46 package. it is designed for atm and sdh/sonet 622mbps. its double-lens optical system is designed for single mode fiber as well as for multimode fiber with a core diameter up to 62.5 m. reliability assurance based on telcordia gr- 468-core. figure 2 - functional schematic v cc gnd data data data out data out may 2003 ordering information zl60007/tbd to-46 with lens -40 c to +85 c zl60007 1310nm, 1550nm 622mbps pin with preamplifier data sheet
zl60007 data sheet 2 zarlink semiconductor inc. operating conditions: 25c case temperatur e/3.3 v supply voltage/fiber: si nglemode to multimode 62.5/125 m note 1: p f =5 w peak-peak power at 10mhz/50% duty cycle note 2: pf = 1mw average power note 3: ber 10 -9 with a 2 23 -1 prbs at 622mbps note 4: measured with stm-4 filter on electrical output. i.e. 467 mhz note 5: penalty at 10 -10 ber equals 0.26 db note 6: the typical value corresponds to the l oad presented by a following limiting amplifier optical and electrical characteristics parameter symbol min typ max unit test condition responsivity, differential r 14 22 33 kv/w =1310nm, r l= 100 ?, note 1 output voltage amplitude, differential ? vo 1.4 v r l= 100 ?, note 2 bandwidth (3db el ) f c 450 mhz p f = 10w, r l = 100 ? optical saturation level (average) p sat 03 dbm =1310nm note 3 noise-equivalent power nep -40 dbm =1310nm note 4 sensitivity (ber 10 -9 ) s -32 -30 dbm =1310nm note 3, 5 dynamic range 35 db output resistance (single) r o 50 ? power dissipation p d 90 165 mw power supply current i dd 30 45 ma absolute maximum ratings parameter symbol min max unit supply voltage v cc 04.5 v storage temperature t stg -55 125 c recommended oper ating conditions parameter symbol min typ max unit supply voltage v cc 3.0 3.3 3.6 v output differentia l load, note 6 r l 100 1000 ? operating temperature t op -40 85 c er = er = er =
data sheet zl60007 3 zarlink semiconductor inc. typical responsivity wavelength fiber core/cladding diam eter numerical aperture 10/125m, na=0.11 50/125m, na=0.20 62.5/125m, na=0.275 differential responsivity 1310nm 22kv/w 22kv/w 22kv/w differential responsivity 1550nm 27kv/w 27kv/w 27kv/w figure 3 - typical re sponsivity vs axial displacement for a multimode fiber figure 4 - responsivity vs. wavelength of coupled input power 0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1 0 0.25 0.5 0.75 1 1.25 1.5 1.75 2 2.25 2.5 z- a xial displacement o f fiber (mm) at r-o pt, relative to-46 lens relative responsivit y relative responsivity % 100 50 0 1800 800 900 1000 1100 1200 1300 1400 1500 1600 1700 nm wavelength figure 5 - typical responsivity vs radial displacement for a multimode fiber 0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1 0 102030405060708090100110120 r- radial dis plac ement of fiber ( m) at z=opt relative responsivit y
zl60007 data sheet 4 zarlink semiconductor inc. figure 6 - output voltage vs input power application guidelines esd handling the receiver is sensitive to electr ostatic discharges. when handling the device, precautions for esd sensitive devices should be taken. these precautions include use of esd protected work area wi th wrist straps, controlled work benches, floors etc. power supply filter power supply decoupling capacitors are recommended fo r optimal performance of the receiver. a filter is recommended to minimize power supply noise. see figure 7. figure 7 - recommended power supply filter 0.1 1 10 100 0.0001 0.001 0.01 0.1 1 pavg (m w) resp (kv/w) 0.01 0.1 1 10 output (v) response oipvsoutput c 0.1 f c 10nf l 10 h host v cc pin / preamp
data sheet zl60007 5 zarlink semiconductor inc. data outputs the outputs data and data signals, are designed to drive a high load >500? ?. it is recommended to use mindspeed mc2044c postamplifier (r in ~4.5? ? ) together with zl60007. figure 8 - recommended post amplifier and coupling capacitors zl60007 output mc2044c c 10nf c 10nf
b o t t o m v i e w ( 1 0 : 1 ) s i d e v i e w ? z a r l i n k s e m i c o n d u c t o r 2 0 0 2 . a l l r i g h t s r e s e r v e d . i s s u e a c n d a t e a p p r d . p r e v i o u s p a c k a g e c o d e s t i t l e d r a w i n g t y p e p a c k a g e c o d e 1 j s 0 0 4 0 7 8 r 1 a 2 2 - m a r - 0 3 t d / b e j s 0 0 4 0 7 8 p a c k a g e d r a w i n g , t o - 4 6 w i t h l e n s t b 2 , 5 4 1 , 1 7 n - 0 0 , 0 5 + ( 3 x ) 0 , 4 5 n - 0 , 0 4 0 , 0 3 + ( 4 x ) n 1 , 0 2 m a x 1 , 0 2 4 5 3 , 6 r 2 , 7 3 , 8 0 , 6 1 3 , 4 6 ` 0 , 7 6 n 4 , 7 l e n s n 1 . 5 ` 0 . 0 5 r 0 , 4 m a x * 0 , 3 3 m a x b r a z e d * 0 , 2 5 m a x g l a s s o v e r m o u l d ( 3 x ) n o t e s : - 1 . a l l d i m e n s i o n s i n m m . 2 . g e n e r a l t o l . i s o - 2 7 6 8 - m k . 3 . c o a t i n g : c a s e : n i 1 , 5 - 2 , 5 m . h e a d e r : n i m i n 0 , 5 m / a u m i n 1 , 5 m .
www.zarlink.com information relating to products and services furnished herein by zarlink semiconductor inc. or its subsidiaries (collectively ?zarlink?) is believed to be reliable. however, zarlink assumes no liability for errors that may appear in this publication, or for liability otherwise arising from t he application or use of any such information, product or service or for any infringement of patents or other intellectual property rights owned by third parties which may result from such application or use. neither the supply of such information or purchase of product or service conveys any license, either express or implied, u nder patents or other intellectual property rights owned by zarlink or licensed from third parties by zarlink, whatsoever. purchasers of products are also hereby notified that the use of product in certain ways or in combination with zarlink, or non-zarlink furnished goods or services may infringe patents or other intellect ual property rights owned by zarlink. this publication is issued to provide information only and (unless agreed by zarlink in writing) may not be used, applied or re produced for any purpose nor form part of any order or contract nor to be regarded as a representation relating to the products or services concerned. the products, t heir specifications, services and other information appearing in this publication are subject to change by zarlink without notice. no warranty or guarantee express or implied is made regarding the capability, performance or suitability of any product or service. information concerning possible methods of use is provided as a guide only and does not constitute any guarantee that such methods of use will be satisfactory in a specific piece of equipment. it is the user?s responsibility t o fully determine the performance and suitability of any equipment using such information and to ensure that any publication or data used is up to date and has not b een superseded. manufacturing does not necessarily include testing of all functions or parameters. these products are not suitable for use in any medical products whose failure to perform may result in significant injury or death to the user. all products and materials are sold and services provided subject to zarlink?s conditi ons of sale which are available on request. purchase of zarlink?s i 2 c components conveys a licence under the philips i 2 c patent rights to use these components in and i 2 c system, provided that the system conforms to the i 2 c standard specification as defined by philips. zarlink, zl and the zarlink semiconductor logo are trademarks of zarlink semiconductor inc. copyright zarlink semiconductor inc. all rights reserved. technical documentation - not for resale for more information about all zarlink products visit our web site at


▲Up To Search▲   

 
Price & Availability of ZL60007TBD

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X